Peak shaving

piekafvlakking · peak shaving · écrêtement des pointes · peak clipping · piekbeperking · peak reduction

Energy glossary

Peak shaving means lowering your highest moments of electricity use, with a battery or smarter EV charging, so you pay less for capacity and stay within your grid connection.

What it means

Most sites use far less power than their maximum for most of the day. A few short moments create the peaks: machines starting together, all cars plugging in at 8:00, kitchen and heating running at once. Peak shaving cuts the tops off those moments.

Think of a water tower. It fills slowly all day and delivers a lot of water at once when the town needs it, so the pipe from the pumping station can stay small. There are three ways to shave a peak:

  • Shift: move flexible loads, such as EV charging, to quieter moments.
  • Limit: cap the power of charge points with load balancing.
  • Cover: let a battery discharge during the peak and recharge later.

An example

Example (hypothetical): a sports centre in Leuven normally uses 60 kW. Around 18:00, pool pumps, the kitchen and eight charge points run together and the site reaches 110 kW. A battery set to discharge above 80 kW covers the extra 30 kW for about an hour, which takes roughly 30 kWh. The monthly peak becomes 80 kW instead of 110 kW.

Why it matters for your company

Lower peaks mean a lower capacity tariff in Flanders. They also free room under your grid connection capacity, so you can add charge points or machines without an immediate connection upgrade.

How BeLoaded helps

BeLoaded combines company batteries and load balancing, and the EMS decides from moment to moment which one shaves the peak.

Sources

  1. Vlaamse Nutsregulator – Capaciteitstarief
  2. Vlaamse Nutsregulator – Tips om je verbruik te spreiden met een digitale meter

Updated: 29 October 2026

Frequently asked questions

Is peak shaving the same as saving energy?

No. Saving energy lowers the total number of kWh you use over a month. Peak shaving lowers the highest power you draw at one moment, measured in kW. You can use exactly the same amount of energy and still pay less network costs, because the same kWh are spread over more time. In Flanders this directly lowers the capacity tariff, which is based on 15-minute peaks.

Do I need a battery for peak shaving?

Not always. Many peaks come from loads that can wait a little, such as EV charging, heating boilers or compressors. Shifting or slowing those down often removes the biggest peaks without new hardware. A battery helps when the peak comes from processes you cannot move, like machines or kitchens running at fixed times, or when you also want to store solar power or trade on energy markets.

Not sure where to start?

Answer four questions and get honest advice for your site, including when a battery is not the answer.