Capacity tariff

capaciteitstarief · tarif capacitaire · capacity charge · peak tariff · monthly peak · maandpiek · capacity tariff Belgium

Energy glossary

The capacity tariff is the part of your network costs in Flanders based on your highest 15-minute power peak each month, not only on the kWh you use.

What it means

Since 1 January 2023, part of the network costs in Flanders is charged through the capacity tariff. Your meter measures your average power in every 15-minute block. The highest block in a calendar month is your monthly peak, expressed in kilowatts (kW). You pay on the average of your last 12 monthly peaks. Households always pay for at least 2.5 kW, even when their peak is lower.

Think of a motorway toll based on the widest lane you ever needed, not on how far you drove. One short burst of power can set your cost for a whole year. If the difference between kW and kWh is fuzzy, start there.

Companies on low voltage in Flanders pay the capacity tariff too. Companies on medium or high voltage pay on their monthly peaks and the capacity they reserved. The rules differ by region: Brussels and Wallonia do not use the Flemish peak-based model for small connections in 2026.

An example

Example (hypothetical): a logistics company near Mechelen normally draws 80 kW. Every morning at 7:30, ten electric vans start charging at the same time as the heating. The meter records a peak of 140 kW. Because this happens every month, the 12-month average sits near 140 kW. If the vans charge one after the other through the night, the peak drops to about 95 kW, and the billed average follows it down month by month.

Why it matters for your company

The capacity tariff rewards a flat consumption profile. Adding EVs, heat pumps or machines without a plan pushes your peak up, and one bad month stays in the average for a year. Peak shaving is the most direct way to lower this part of the bill.

How BeLoaded helps

Load balancing keeps EV charging under a limit you choose, and a company battery can cover short peaks. The BeLoaded EMS steers both together.

Sources

  1. Vlaamse Nutsregulator – Capaciteitstarief
  2. Sibelga – Capacity rate (Brussels)
  3. Test-Achats – Nouveaux tarifs d'électricité 2026 en Wallonie

Updated: 29 October 2026

Frequently asked questions

Do companies in Flanders pay the capacity tariff?

Yes. Companies on a low-voltage connection with a meter that records quarter-hour values pay it the same way as households: on the average of their monthly 15-minute peaks over the last 12 months. Companies on medium or high voltage pay network costs based on their measured monthly peaks and the capacity they reserved with the network operator. In both cases, a lower peak means lower network costs.

Is there a capacity tariff in Brussels and Wallonia in 2026?

Not in the Flemish form. In Brussels, Sibelga charges small low-voltage connections a fixed yearly capacity fee based on the size of the connection in kVA, not on measured peaks. In Wallonia, the 2026 tariffs for smaller low-voltage connections use time-of-use bands, so when you consume matters more than your peak. Larger and medium-voltage connections are billed differently, so check your network operator's tariff sheet.

How long does one high peak affect my bill?

In Flanders, up to 12 months. Your bill uses the average of your last 12 monthly peaks, so one high peak in January still counts until the next January. That is why preventing peaks works better than reacting afterwards. Tools that cap your power automatically, such as load balancing for charge points or a company battery, stop the peak before the meter records it.

Not sure where to start?

Answer four questions and get honest advice for your site, including when a battery is not the answer.